Configuring The Time Zone - Avaya 8800 Commissioning Manual

Initial steps using the CLI
mtu <bytes>
multicast-resource-reservation <value>
name <prompt>
portlock <on|off>
sendAuthenticationTrap <true|false>
topology <on|off>
udp-checksum <enable|disable>
udpsrc-by-vip <enable|disable>
vlan-bysrcmac <enable|disable>

Configuring the time zone

Set the time zone to specify the time zone for your location, and configure settings for Daylight
Saving Time (DST).
Procedure steps
1. Configure the time zone by using the following command:
2. Save the changed configuration to the boot.cfg and pcmboot.cfg files.
3. Restart the switch.
Variable definitions
Use the data in the following table to use the config bootconfig tz command.
42 Commissioning
Variable
config bootconfig tz
Value
Sets MTU (with CRC) to one of three
values: 1522, 1950 and 9600 bytes. The
MTU value in the range of 1522 to 9600.
Reserves MGIDs for IPMC use. value is the
number of MGIDs reserved for IPMC use in
the range from 64 to 4083.
Changes the system name. prompt is the
box or root level prompt . The string length
ranges from 0 to 255.
Turns portlock on or off.
Sets authentication trap to true or false.
Turns topology on/off.
Enables or disables UDP Checksum
calculation.
Enables or disables the Virtual IP as the
UDP source.
Enables or disables the vlan-bysrcmac
feature.
June 2011