Avaya Cajun P882 User Manual page 503

Multiservice switch

Hide thumbs Also See for Cajun P882:

Table of Contents

Using the CLI

Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide, v5.3.1

Table 15-1. Add AppleTalk Interface Dialog Box Parameters

Enter the ending network number. The network

number specifies the range of AppleTalk network

numbers for extended networks. Each number in the

range must be an integer between 0 and 65279.

Enter the interface network number. This number

specifies the network number the interface is using.

Enter the interface node identification number. This

number must be between 1 and 253.

Select whether to enable or disable the administrator

state. The administrator state determines if the

interface is operational from a management point of

Select the default AppleTalk zone to be used by this

interface. Zone names may be up to 32 characters in

5. Click Apply to add the new AppleTalk interface, or

CANCEL to restore previous settings. Once you click Apply,

you are returned to the AppleTalk Interfaces dialog box

(Figure 15-4.)

Figure 15-4. AppleTalk Interfaces

Use the following CLI commands in interface mode to create an

AppleTalk interface:

(config if-:<interface-name>)# appletalk cable-range <cable-

Configuring AppleTalk Routing

If the Network Range Start value equals 0,

then the Network Range End value must also

This value must be within the Network Range

or be equal to 0.

Only if the Network Number is equal to 0, can

the Node also be equal to 0.

P550r P580 P880