Verifying The Upgrade; Upgrading From V4.X To V5.X - Avaya Cajun P882 User Manual

Multiservice switch

Hide thumbs Also See for Cajun P882:

Table of Contents

Verifying the Upgrade

To reset the Active Supervisor to the Standby Supervisor:

1. In the navigation pane, expand the System folder.

2. Select System Reset.

The System Reset Web page is displayed in the content

pane (Figure A-3).

3. Select Yes in response to the question, Do you want to

reset the switch?

To reset the switch after downloading new application software, use

the following CLI command:

<configure># reset

For more information on this command, see Chapter 29, "System,"

in the Command Reference Guide for the Avaya P550R, P580, P880, and

P882 Multiservice Switches

To verify that the old Active supervisor is now the Standby

supervisor, the LED display window (marquee) should scroll

Standby and the code version.

If a redundant supervisor module is running a 4.x version of applica-

tion software, it is not upgraded to v5.x if you follow the upgrade

procedure that is described earlier in this appendix.

To upgrade the application software from v4.x to v5.x on a switch

that has a redundant supervisor module, you much upgrade the

application software on each supervisor module individually. To

perform this task:

1. Back up the current software. For information on how to

perform this step, see

2. Back up the previous configuration. For information on how

to perform this step, see

Configuration"

Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide, v5.3.1

"Backing Up the Current Software"

"Backing Up the Previous

on page A-3.

P550r P580 P880