Avaya Cajun P882 User Manual page 252

Chapter 6
SNMP
Table 6-6. MIB, MIB Objects, and OIDs for Adding AFT Entries
MIB
ProminetMib.txt,
version 5.2
6-24
3. Use the following command to disable learning on a port or
port range:
set port allow-learning <mod-swport-range> disable
4. Use the following command to enable known mode on a port
or port range:
set port known-mode <mod-swport-range> enable
* Note: To prevent the flooding of frames that have
unknown destination addresses, enter all ports
on the same VLAN as the port for which you are
enabling MAC address lock.
5. Use the following command to enable intrusion traps on a
port or port range:
set port intrusion-trap <mod-swport-range> enable
6. Use the following command to set the intrusion trap timer to
other than the default setting:
set port intrusion-trap-timer <mod-swport-range>
<intrusion-trap-timer-value>
The MIB objects that you use to perform this procedure are located
in ProminetMib.txt, version 5.2.
To use SNMP to enable the MAC Address Lock feature and traps for
unknown source addresses:
1. Use the MIB objects that are listed in Table 6-6 to manually
add the "permitted" MAC addresses to the AFT.
MIB Object
promL2AddressControlIndex
promL2AddressControlMacAddress
promL2AddressControlPortBinding
promL2AddressControlVlanID
promL2AddressControlPriority
promL2AddressControlPersistence
Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide, Version v5.3.1
OID
1.3.6.1.4.1.2167.5.1.4.3.1.1
1.3.6.1.4.1.2167.5.1.4.3.1.2
1.3.6.1.4.1.2167.5.1.4.3.1.3
1.3.6.1.4.1.2167.5.1.4.3.1.4
1.3.6.1.4.1.2167.5.1.4.3.1.5
1.3.6.1.4.1.2167.5.1.4.3.1.6