Avaya Cajun P882 User Manual page 389

Table 9-33. LDAP Configuration Dialog Box Parameters continued
Parameter
Secondary Server Port
Search Base
Execution Option
Using the CLI
Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide, v5.3.1
Allows You To...
Enter the backup LDAP server port number for the access
control list domain. The port number is used in
conjunction with the secondary server IP address. There
are no special overload values. The default port number is
389.
Enter the search criteria that will be sent to the LDAP
server. The default value is "ou=Devices,
ou=AvayaPolicyManager, o=Avaya".
Note:
Open drop-down menu and select stop-on-error or
ignore-errors. This option lets you decide if you want the
policy to continue being sent to the device, if LDAP
encounters any errors. Select stop-on-error if you want
execution of the policy to stop on the first error
encountered.Select ignore-errors if you want execution
of the policy to continue even if errors are encountered. In
this case, any commands containing errors are ignored.
The default value is stop-on-error.
3. Click APPLY to save your changes, or CANCEL to restore
previous settings.
To configure LDAP settings on a primary and secondary server from
the CLI, enter the following command from configuration mode:
To Change the LDAP search base, use the following CLI command.
<configure># ldap search-base <search-base-DN>
To change the primary LDAP server's primary ip address and port,
use the following CLI command.
<configure># ldap server primary <ip-addr> [<port-
num>]
To change the secondary LDAP server's primary ip address and port,
use the following CLI command.
<configure># ldap server secondary <ip-addr>
[<port-num>]
No default for the Search Base, this field is empty
if the LDAP server has not been installed:
Configuring IP Routing
2 of 2
9-107