CLI Command
Resetting the Standby Supervisor
Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide, v5.3.1
Figure A-5. System Reset Web Page
3. Select Yes in response to the question, Do you want to
reset the switch?
The switch resets and loads the new application software.
To reset the switch after downloading new application software, use
the following CLI command:
<configure># reset
For more information on this command, see Chapter 29, "System,"
in the Command Reference Guide for the Avaya P550R, P580, P880, and
P882 Multiservice Switches
In the previous procedure "Resetting the Active Supervisor," the
procedure forces the Active Supervisor to the Standby mode and the
Standby Supervisor to the Active Supervisor mode. To recover back
to the original state, with both supervisors running new code, reset
the current Active supervisor module.
Upgrading the Application Software
A-9