Modifying Ospf Virtual Links - Avaya Cajun P882 User Manual

Deleting OSPF
Virtual Links
Using the CLI

Modifying OSPF Virtual Links

Using the Web
Agent
Using the CLI
Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide, Version 5.3.1
To delete an OSPF virtual link using the CLI, enter the following
command from Enable/Configure mode:
(configure router: ospf)# [no] area <area-
id> virtual-link <router-id>
Refer to the Command Reference Guide for the Avaya P550R, P580, P880,
and P882 Multiservice Switches, v5.3 for details about this command.
You can modify OSPF virtual links using either the Web Agent or
the CLI.
To modify an OSPF virtual link using the Web Agent:
1. Select Virtual Links from the Routing > IP > OSPF group
on the Web Agent window. The OSPF Virtual Links dialog
box opens (Figure 11-5).
2. Select the virtual link that you want to modify.
3. Refer to Table 11-4 to modify the OSPF Virtual Links dialog
box parameters.
4. Click APPLY to save your changes, or CANCEL to restore
previous settings.
To modify an OSPF virtual link using the CLI, enter the following
command and make your desired changes from Configure mode:
(configure router: ospf)# area <area-id> virtual-
link <router-id> [hello-interval <seconds>]
[retransmit-interval <seconds>] [dead-interval
<seconds>] [{authentication-key <key> | message-
digest-key <key-id> md5 <key>}]
Refer to the Command Reference Guide for the Avaya P550R, P580, P880,
and P882 Multiservice Switches, v5.3 for details about this command.
Configuring the OSPF Routing Protocol
11-17