Avaya Cajun P882 User Manual page 484

Chapter 14
14-2
2. Refer to Table 14-1 to configure the IPX SAP Interface
dialog box parameters:
Table 14-1. IPX SAP Interface Dialog Box Parameters
Parameter
Select
Interface
Network Number
Use Interpacket
Gap
Use Max Packet
Size
Periodic Update
Interval (sec)
Aging Interval
Multiplier
Triggered Updates
Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide, v5.3.1
Allows you to...
Select a SAP interface to modify.
Identifies the IPX interface associated with the
SAP interface.
Identifies the number of the IPX network
associated with the interface.
Select one of the following from the pull-down
menu:
• Disable – if you do not want the IPX SAP
periodic update packets to be sent out over
an interface with no interpacket
transmission delay.
• Enable – If you want to send the IPX SAP
periodic update packets to be sent out over
an interface with an interpacket transmission
delay (default).
Select one of the following from the pull-down
menu:
• Disable – To limit SAP packets to 7 service
entries(default).
• Enable – To allow SAP) packets to contain
the maximum number of services entries
that are allowed by the SAP Interface MTU
(default).
Enter (in seconds) the interval at which periodic
SAP updates are sent out an interface.Default is 60
seconds.
Enter the length of time that information from
received SAP updates are kept as a multiplier of
the Periodic Update Interval.Default is 3.
Select one of the following from the pull-down
menu:
• Disable – To prevent SAP updates from
being immediately transmitted to the
network in response to changes in the
network topology
• Enable – To allow SAP updates to be
immediately transmitted to the network in
response to changes in the network topology
(default).