Chapter 15
Editing an AppleTalk NBP Filter
Using the Web
Agent
Using the CLI
15-18
You can edit an AppleTalk NBP filter using either the Web Agent or
the CLI.
To edit an AppleTalk NBP filter using the Web Agent:
1. Select NBP Filter from the Routing > AppleTalk >
Configuration group on the Web Agent window. The
AppleTalk NBP Filter dialog box opens (Figure 15-15).
Figure 15-15. AppleTalk NBP Filter
2. Refer to Table 15-3 to edit the AppleTalk NBP Filter dialog
box parameters.
3. Click:
CREATE to add a new filter. The Add AppleTalk NBP
—
Filter dialog box opens. See "Creating an AppleTalk NBP
Filter", earlier in this section, for more information.
DELETE to remove the selected NBP filter.
—
CANCEL to restore previous settings.
—
Edit If to add or delete this NBP filter to/from an
—
interface. The Add/Delete Interface to NBP Filter
dialog box opens. See "Adding or Deleting Interfaces to
NBP Filter", later in this section, for more information.
To edit an AppleTalk NBP filter using the CLI, enter the following
command in Interface mode:
(config-if <interface-name>:)# appletalk access-
list <access-list-number> <permit | deny> nbp
<string>
Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide, v5.3.1