Password Recovery; Downloading New Operational Code - Avaya Cajun P882 User Manual

Appendix B

Password Recovery

Syntax
Description

Downloading New Operational Code

B-2
Starting up threads ...
Periodic Task
Network Interface
Front Panel Display
Download
Command Line Parser
Boot process complete - system is now operational.
Boot Software Revision: V5.3
Press Ctrl-P for previous command, Ctrl-N for next command
download Download to FEPROM
feprom Flash EPROM configuration
initLogins Restore default passwords
ip IP Configuration
manuf Get/Set MAC address
nvram Initializes NV RAM-diags run upon reboot
peek Read from memory
ping Ping host [tries] [delay]
poke Write to memory
reset Reset System
Boot>
The following command is used to reset the switch to the factory
default passwords.
initLogins
Boot> initLogins set <0=no change, 1=factory default>
Using a value of zero will retain the current passwords in NVRAM
upon resetting the switch. Using a value of one will restore the
factory default passwords in NVRAM upon resetting the switch.
To download new operational code in BOOT mode into APP1 or
APP2.
* Note: The Avaya P550R/P580/P880/P882 Multiservice switch
does not have an IP address assigned to the console
ethernet port when it comes up in BOOT mode.
Therefore, a user must assign an IP address (and default
Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide, v5.3.1