CLI Commands
for RIP
Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide, Version 5.3.1
RIP2 MD5 Authentication sequence numbers do not persist after
you reset the switch.
To set up an NBMA neighbor on RIP, you must first create a RIP
interface.
1. After you create a RIP interface, enter the following
command at the prompt:
router rip
The Avaya(configure router:rip)# prompt is
displayed.
2. Enter the following at the prompt:
nbma-neighbor <ip address>
Configuring the OSPF Routing Protocol
11-37