35
Smartport Commands
switchxxxxxx(config-if)#smartport switchport trunk allowed vlan add 1-5
35.16 smartport switchport trunk native vlan
Use the smartport switchport trunk native vlan Interface Configuration (Ethernet,
port-channel) mode command to define the native VLAN when the interface is in
trunk mode. Use the no form of this command to restore the default configuration.
Syntax
native
vlan-id
smartport switchport trunk native vlan
-
Parameters
native-vlan-id—Specifies the native VLAN ID.
Default Configuration
VLAN 1
Command Mode
Interface Configuration (Ethernet, port-channel) mode
User Guidelines
This command is an extension of the switchport trunk native vlan CLI command.
Unlike the switchport trunk native vlan CLI command, this command may also be
applied to the default VLAN when the interface belongs to the default VLAN as
egress tagged port.
Example
Define the native VLAN when port 1 is in trunk mode:
switchxxxxxx(config)interface gi1
switchxxxxxx(config-if)#smartport switchport trunk native vlan 1
35.17 smartport storm-control broadcast enable
Use the smartport storm-control broadcast enable Interface Configuration
(Ethernet, port-channel) mode command to enable storm control on a Smartport
port. Use the no form of this command to disable storm control..
572
78-21075-01 Command Line Interface Reference Guide