Power Inline Limit - Cisco 300 Series Cli Manual

Power over Ethernet (PoE) Commands
78-21075-01 Command Line Interface Reference Guide
Default Configuration
Inline power traps are disabled.
Command Mode
Global Configuration mode
Example
The following example enables inline power traps.
switchxxxxxx(config)# power inline traps enable
25.6

power inline limit

Use the power inline limit Interface Configuration mode command to configure the
power limit per port on an interface. Use the no form of the command to return to
default.
Syntax
power
power inline limit
no power inline limit
Parameters
power—States the port power consumption limit in Milliwatts (Range:The
parameter range depends on the current working mode:In POE mode: 0-15400, In
POE+ mode: 0–30000)
Default Configuration
The default value is the maximum power allowed in the specific working mode:
15.4W.
•
In POE mode: 15.4W
•
In POE+ mode: 30W
Command Mode
Interface Configuration (Ethernet) mode
25
379