Bridge Multicast Ipv6 Forbidden Ip-Address - Cisco 300 Series Cli Manual

29
416
Default Configuration
No Multicast addresses are defined.
The default option is add.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
To register the group in the bridge database without adding or removing ports or
port channels, specify the ipv6-multicast-address parameter only.
Static Multicast addresses can be defined on static VLANs only.
You can execute the command before the VLAN is created.
Examples
Example 1 - The following example registers the IPv6 address to the bridge table:
switchxxxxxx(config)#
switchxxxxxx(config-if)#
Example 2 - The following example registers the IPv6 address and adds ports
statically.
switchxxxxxx(config)#
switchxxxxxx(config-if)#
gi1-2
add

29.11 bridge multicast ipv6 forbidden ip-address

Use the bridge multicast ipv6 forbidden ip-address Interface Configuration (VLAN)
mode command to forbid adding or removing a specific IPv6 Multicast address to
or from specific ports. To restore the default configuration, use the no form of this
command.
interface vlan 8
bridge multicast ipv6 ip-address
interface vlan 8
bridge multicast ipv6 ip-address
78-21075-01 Command Line Interface Reference Guide
Address Table Commands
FF00:0:0:0:4:4:4:1
FF00:0:0:0:4:4:4:1