Switchport Trunk Native Vlan - Cisco Nexus 5500 Series Command Reference Manual

Chapter S Commands

switchport trunk native vlan

To configure the native VLAN ID for the virtual Ethernet interface, use the switchport trunk native
vlan command. To remove the native VLAN ID from the virtual Ethernet interface, use the no form of
this command.
Syntax Description
vlan_ID
Command Default
None
Command Modes Interface configuration mode
Virtual Ethernet interface configuration mode
Command History Release
5.2(1)N1(1)
Usage Guidelines
This command does not require a license.
Examples
This example shows how to set VLAN 3 as the native trunk port:
switch# configure terminal
switch(config)# interface vethernet 1
switch(config-if)# switchport trunk native vlan 3
switch(config-if)#
Related Commands Command
interface vethernet
show running-config
OL-27880-02
switchport trunk native vlan vlan_ID
no switchport trunk native vlan
VLAN ID of the native VLAN when this port is in trunking mode. The
range is from 1 to 4094.
Modification
This command was introduced.
Description
Configures a virtual Ethernet interface.
Displays the running system configuration information.
Cisco Nexus 5500 Series NX-OS Layer 2 Interfaces Command Reference
switchport trunk native vlan
1257