Show Interfaces Advertise - Cisco 300 Series Cli Manual

Ethernet Configuration Commands
78-21075-01 Command Line Interface Reference Guide
•
detailed—Displays information for non-present ports in addition to present
ports.
Command Mode
EXEC mode
Default Configuration
Display for all interfaces. If detailed is not used, only present ports are displayed.
Example
The following example displays the status of all configured interfaces.
switchxxxxxx# show interfaces status
Port Type Duplex Speed Neg
------ --------- ------ ----- -------- ----
gi1 1G-Copper Full
gi2 1G-Copper --
PO Type Duplex Speed
----- ------- ------ -----
Po1 1G Full

23.17 show interfaces advertise

Use the show interfaces advertise EXEC mode command to display
auto-negotiation advertisement information for all configured interfaces or for a
specific interface.
Syntax
show interfaces advertise
Parameters
•
interface-id—Specifies an interface ID. The interface ID can be one of the
following types: Ethernet port or Port-channel.
Flow
ctrl
1000 Disabled Off
-- -- --
Flow
Neg control
------- ----
10000 Disabled Off
[interface-id | detailed
Link Back Mdix
State Pressure Mode
------ -------- --
Up Disabled Off
Down -- --
Link
State
------
Up
]
23
359