Ipv6 Mld Query-Max-Response-Time; Ipv6 Mld Last-Member-Query-Count - Cisco 300 Series Cli Manual

IPv6 MLD Snooping Commands
78-21075-01 Command Line Interface Reference Guide
39.9

ipv6 mld query-max-response-time

Use the ipv6 mld query-max-response-time Interface Configuration mode
command to configure the Query Maximum Response time. Use the no format of
the command to return to default.
Syntax
ipv6 mld query-max-response-time
no ipv6 mld query-max-response-time
Parameter
seconds—Maximum response time, in seconds, advertised in MLD queries.
(Range: 5–20)
Default Configuration
10
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
This command provides the maximum response time value if this value is not
received in MLD general query messages. A field for this value is present in
MLDv2 general query messages, but this field may be blank. There is no field for
this value in MLDv1 general query messages.
Example
switchxxxxxx(config)# interface vlan 1
switchxxxxxx(config-if)# ipv6 mld query-max-response-time 5

39.10 ipv6 mld last-member-query-count

Use the ipv6 mld last-member-query-count Interface Configuration mode
command to configure the Last Member Query Count. This is the number of
Multicast address specific queries sent before the router assumes there are no
local listeners.The Last Listener Query Count is also the number of Multicast
seconds
39
661