Cisco 300 Series Cli Manual page 401

Port Channel Commands
78-21075-01 Command Line Interface Reference Guide
Parameters
interface-id—Specify an interface ID. The interface ID must be a Port Channel.
Command Mode
EXEC mode
Examples
Example 1 - The following example displays information on all port-channels.
switchxxxxxx# show interfaces port-channel
Load balancing: src-dst-mac.
Gathering information...
Channel Ports
------- -----
Po1 Active: gi1,Inactive: gi2-3
Po2 Active: gi5 Inactive: gi4
Example 2 - The following example displays information on port-channels
containing port 1
switchxxxxxx# show interfaces switchport gi1
Gathering information...
Name: gi1
Switchport: enable
Administrative Mode: access
Operational Mode: down
Access Mode VLAN: 1
Access Multicast TV VLAN: none
Trunking Native Mode VLAN: 1
Trunking VLANs Enabled: 1
General PVID: 1
General VLANs Enabled: none
2-4094 (Inactive)
28
401