Cisco 300 Series Cli Manual page 206

12
206
Syntax
username groupname {v1 | v2c | [
snmp-server user
sha} auth-password [priv priv-password] ]}
encrypted snmp-server user
{ md5 | sha} encrypted-auth-password [priv encrypted-priv-password] ]}
no snmp-server user
Parameters
•
username—Define the name of the user on the host that connects to the
agent. (Range: Up to 20 characters). For SNMP v1 or v2c, this username
must match the community string entered in
•
groupname—The name of the group to which the user belongs. The group
should be configured using the command
parameters (no specific order of the 2 command configurations is imposed
on the user). (Range: Up to 30 characters)
•
host
remote —IPaddress (IPv4, IPv6 or IPv6z) or host name of the remote
SNMP host. See
•
v1—Specifies that the user is a v1 user.
•
v2c—Specifies that the user is a v2c user..
•
v3—Specifies that the user is a v3 user..
•
auth—Specifies which authentication level is to be used.
•
md5—Specifies the HMAC-MD5-96 authentication level.
•
Sha—Specifies the HMAC-SHA-96 authentication level.
•
auth-password—Specifies the authentication password. Range: Up to 32
characters.
•
encrypted-auth-password—Specifies the authentication password in
encrypted format.
•
priv-password—Specifies the privacy password (The encryption algorithm
used is data encryption standard - DES). Range: Up to 64
characters.encrypted-priv-password—Specifies the privacy password in
encrypted format.
Network Management Protocol (SNMP) Commands
username groupname {v1 | v2c | [
username [remote host]
IPv6z Address Conventions.
78-21075-01 Command Line Interface Reference Guide
host] v3[
remote auth
remote
snmp-server host.
snmp-server group with v1 or v2c
{ md5 |
host] v3[
auth