Lldp Med Notifications Topology-Change - Cisco 300 Series Cli Manual

Link Layer Discovery Protocol (LLDP) Commands
78-21075-01 Command Line Interface Reference Guide
•
tlv—Specifies the TLV that should be included. Available TLVs are:
network-policy, location, and poe-pse, inventory. The capabilities TLV is
always included if LLDP-MED is enabled.
•
disable - disable LLDP MED on the port
Default Configuration
Enabled with network-policy TLV
Command Mode
Interface Configuration (Ethernet) mode
Example
The following example enables LLDP MED with the location TLV on gi3.
switchxxxxxx(config)#
switchxxxxxx(config-if)#

37.15 lldp med notifications topology-change

Use the lldp med notifications topology-change Interface Configuration (Ethernet)
mode command to enable sending LLDP MED topology change notifications on a
port. Use the no form of this command to restore the default configuration.
Syntax
lldp med notifications topology-change
no lldp med notifications topology-change
Parameters
•
enable—Enables sending LLDP MED topology change notifications.
•
disable—Disables sending LLDP MED topology change notifications.
Default Configuration
Disable is the default.
interface gi3
lldp med enable location
{enable | disable}
37
613