Show Tech-Support - Cisco 300 Series Cli Manual

5
112
5.20

show tech-support

Use the show tech-support EXEC mode command to display system and
configuration information that can be provided to the Technical Assistance Center
when reporting a problem.
Syntax
config
show tech-support [
Parameters
•
Memory—Displays memory and processor state data.
•
Config—Displays switch configuration within the CLI commands supported
on the device.
Default Configuration
By default, this command displays the output for technical-support-related show
commands. Use keywords to specify the type of information to be displayed. If
you do not specify any parameters, the system displays all configuration and
memory data.
Command Types
Switch command.
Command Mode
EXEC mode
User Guidelines
Caution: Avoid running multiple show tech-support commands on a switch or
multiple switches on the network segment. Doing so may cause starvation of
some time sensitive protocols, like STP.
The show tech-support command may timeout if the configuration file output
takes longer to display than the configured session timeout time. If this happens,
enter a set logout timeout value of 0 to disable automatic disconnection of idle
sessions or enter a longer timeout value.
The show tech-support command output is continuous, it does not display one
screen at a time. To interrupt the output, press Esc.
memory
] [ ]
78-21075-01 Command Line Interface Reference Guide
System Management Commands