37
620
Default Configuration
The location is not configured.
Command Mode
Interface Configuration (Ethernet) mode
Example
The following example configures the LLDP MED location information on gi2 as a
civic address.
switchxxxxxx
(config)# interface gi2
switchxxxxxx
(config-if)# lldp med location civic-address 616263646566
37.22 show lldp configuration
Use the show lldp configuration Privileged EXEC mode command to display the
LLDP configuration for all ports or for a specific port.
Syntax
show lldp configuration
Parameters
•
interface-id—Specifies the port ID.
•
detailed—Displays information for non-present ports in addition to present
ports.
Default Configuration
Display for all ports. If detailed is not used, only present ports are displayed.
Command Mode
Privileged EXEC mode
Examples
Example 1 - Display LLDP configuration for all ports.
Link Layer Discovery Protocol (LLDP) Commands
[interface-id | detailed
78-21075-01 Command Line Interface Reference Guide
]