Lldp Management-Address - Cisco 300 Series Cli Manual

37
608
lldp optional-tlv 802.1 protocol
The protocols selected are advertised.
lldp optional-tlv 802.1 protocol
- The protocols selected are not advertised.
Parameters
•
lldp optional-tlv 802.1 pvid—Advertises the PVID of the port.
•
lldp optional-tlv 802.1 ppvid add/remove
advertising. (range: 0–4094). PPVID = 0 indicates that the port is not
capable of supporting port and protocol VLANs and/or the port is not
enabled with any protocol VLANs.
•
vlan-id
add/remove
•
add/remove {stp | rstp | mstp | pause | 802.1x | lacp | gvrp}
advertise the specified protocols; remove specifies not to advertise the
specified protocol.
Default Configuration
No optional TLV is transmitted.
Command Mode
Interface Configuration (Ethernet) mode
Example
(config)# lldp optional-tlv 802.1 protocol add stp
switchxxxxxx

37.10 lldp management-address

Use the lldp management-address Interface Configuration (Ethernet) mode
command to specify the management address advertised by an interface. Use the
no form of this command to stop advertising management address information.
Syntax
lldp management-address
no lldp management-address
Link Layer Discovery Protocol (LLDP) Commands
add {stp | rstp | mstp | pause | 802.1x | lacp | gvrp}
remove {stp | rstp | mstp | pause | 802.1x | lacp | gvrp}
—Adds/removes VLAN for advertising (range: 0–4094).
{ip-address | none | automatic [interface-id]}
78-21075-01 Command Line Interface Reference Guide
ppvid
—Adds/removes PPVID for
—Add specifies to
-