Show Ipv6 Dhcp Interface - Cisco 300 Series Cli Manual

DHCPv6 Commands
78-21075-01 Command Line Interface Reference Guide
52.9

show ipv6 dhcp interface

Use the show ipv6 dhcp interface command in User EXEC or Privileged EXEC
mode to display DHCP for IPv6 interface information.
Syntax
show ipv6 dhcp interface [
Parameters
interface-id
—Interface identifier.
Command Mode
User EXEC
Privileged EXEC
User Guidelines
If no interfaces are specified in the command, all interfaces on which DHCP for
IPv6 (client or server) is enabled are displayed. If an interface is specified in the
command, only information about the specified interface is displayed.
Examples
Example 1—The following is sample output from this command when only the
Stateless service is enabled:
show ipv6 dhcp interface
gi is in client mode
DHCP Operational mode is enabled
Stateless Service is enabled
Reconfigure service is enabled
Information Refresh Minimum
Information Refresh Time: 86400 seconds
Received Information Refresh Time: 3600 seconds
Remain Information Refresh Time: 411 seconds
DHCP server:
Address FE80::202:FCFF:FEA1:7439, DUID 000300010002FCA17400
interface-id
]
Time: 600 seconds
52
871