Ethernet Configuration Commands
78-21075-01 Command Line Interface Reference Guide
switchxxxxxx
#
clear counters gi5.
23.14 set interface active
Use the set interface active EXEC mode command to reactivate an interface that
was shut down.
Syntax
{interface-id}
set interface active
Parameters
interface-id—Specifies an interface ID. The interface ID can be one of the
following types: Ethernet port or Port-channel.
Command Mode
EXEC mode
User Guidelines
This command is used to activate interfaces that were configured to be active, but
were shut down by the system.
Example
The following example reactivates gi1
switchxxxxxx
#
set interface active gi1
23.15 show interfaces configuration
Use the show interfaces configuration EXEC mode command to display the
configuration for all configured interfaces or for a specific interface.
Syntax
show interfaces configuration
Parameters
•
interface-id—Specifies an interface ID. The interface ID can be one of the
following types: Ethernet port or Port-channel.
[interface-id | detailed
]
23
357