Switchport Private-Vlan Trunk Native Vlan Tag - Cisco Catalyst 4500 Series Command Reference Manual

Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches

switchport private-vlan trunk native vlan tag

To control the tagging of the native VLAN traffic on 802.1Q private VLAN trunks, use the switchport
private-vlan trunk native vlan tag command. To remove the control of tagging (and default to the global
setting), use the no form of this command.
Syntax Description
This command has no arguments or keywords.
Defaults
The default setting is global; the settings on the port are determined by the global setting.
Command Modes Interface configuration mode
Command History Release
12.1(12c)EW
12.2(18)EW
Usage Guidelines The configuration created with this command only applies to ports that are configured as private VLAN
trunks.
Examples This example shows how to enable 802.1Q native VLAN tagging on a PVLAN trunk:
Switch(config-if)# switchport private-vlan trunk native vlan tag
Switch(config-if)#
Related Commands Command
show interfaces switchport
switchport mode
OL-27596 -01
switchport private-vlan trunk native vlan tag
no switchport private-vlan trunk native vlan tag
Modification
Support for this command was introduced on the Catalyst 4500 series switch.
Removed vlan-id keyword.
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
switchport private-vlan trunk native vlan tag
Description
Displays the administrative and operational status of a
switching (nonrouting) port.
Enables the interface type.
2-1069