Bridge Multicast Forbidden Ip-Address - Cisco 300 Series Cli Manual

29
410
switchxxxxxx(config-if)#
29.6

bridge multicast forbidden ip-address

Use the bridge multicast forbidden ip-address Interface Configuration (VLAN)
mode command to forbid adding or removing a specific IP Multicast address to or
from specific ports. Use the no form of this command to restore the default
configuration.
Syntax
bridge multicast forbidden ip-address
{ethernet interface-list | port-channel port-channel-list}
no bridge multicast forbidden ip-address {
Parameters
•
ip-multicast-address—Specifies the group IP Multicast address.
•
add—Forbids adding ports to the group.
•
remove—Forbids removing ports from the group.
•
interface-list
ethernet
nonconsecutive Ethernet ports with a comma and no spaces. Use a hyphen
to designate a range of ports.
•
port-channel-list
port-channel
nonconsecutive port-channels with a comma and no spaces. Use a hyphen
to designate a range of port channels.
Default Configuration
No forbidden addresses are defined.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
Before defining forbidden ports, the Multicast group should be registered.
You can execute the command before the VLAN is created.
bridge multicast ip-address
{ip-multicast-address} {add | remove}
ip-multicast-address
—Specifies a list of Ethernet ports. Separate
—Specifies a list of port channels. Separate
78-21075-01 Command Line Interface Reference Guide
Address Table Commands
239.2.2.2 add gi9
}