Ip Dhcp Relay Address (Interface) - Cisco 300 Series Cli Manual

DHCP Relay Commands
78-21075-01 Command Line Interface Reference Guide
Syntax
ip dhcp relay address
no ip dhcp relay address [
Parameters
ip-address—Specifies the DHCP server IP address. Up to 8 servers can be
defined.
Default Configuration
No server is defined.
Command Mode
Global Configuration mode
User Guidelines
Use the ip dhcp relay address command to define a global DHCP Server IP
address. To define a few DHCP Servers, use the command a few times.
To remove a DHCP Server, use the no form of the command with the
argument.
The no form of the command without the
defined DHCP servers.
Example
The following example defines the DHCP server on the device.
switchxxxxxx(config)#
46.4

ip dhcp relay address (Interface)

Use the ip dhcp relay address Interface Configuration (VLAN, Ethernet,
Port-channel) command to define the DHCP servers available by the DHCP relay
for DHCP clients connected to the interface. Use the no form of this command to
remove the server from the list.
Syntax
ip dhcp relay address
ip-address
ip-address
]
ip-address
ip dhcp relay address
ip-address
argument deletes all global
176.16.1.1
46
ip-address
761