Lldp Timer - Cisco 300 Series Cli Manual

Link Layer Discovery Protocol (LLDP) Commands
78-21075-01 Command Line Interface Reference Guide
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
LLDP manages LAG ports individually. LLDP data received through LAG ports is
stored individually per port.
LLDP operation on a port is not dependent on the STP state of a port. I.e. LLDP
frames are received on blocked ports.
If a port is controlled by 802.1x, LLDP operates only if the port is authorized.
Example
switchxxxxxx (config)# interface gi1
switchxxxxxx
(config-if)# lldp receive
37.4

lldp timer

Use the lldp timer Global Configuration mode command to specify how often the
software sends LLDP updates. Use the no form of this command to restore the
default configuration.
Syntax
lldp timer seconds
no lldp timer
Parameters
timer seconds —Specifies, in seconds, how often the software sends LLDP
updates (range: 5-32768 seconds).
Default Configuration
30 seconds.
Command Mode
Global Configuration mode
37
603