Show Ip Igmp Snooping Groups - Cisco 300 Series Cli Manual

IGMP Snooping Commands
78-21075-01 Command Line Interface Reference Guide
IGMP snooping last member query counter: admin 2 oper 2
IGMP snooping last member query interval: admin 1000 msec oper 500 msec
IGMP snooping last immediate leave: enable
Automatic learning of Multicast router ports is enabled

38.20 show ip igmp snooping groups

The show ip igmp snooping groups EXEC mode command displays the Multicast
groups learned by the IGMP snooping.
Syntax
show ip igmp snooping groups [vlan
source ip-address
[ ]
Parameters
vlan-id
vlan —Specifies the VLAN ID.
address ip-multicast-address—Specifies the IP multicast address.
source ip-address—Specifies the IP source address.
Command Mode
EXEC mode
User Guidelines
To see all Multicast groups learned by IGMP snooping, use the show ip igmp
snooping groups command without parameters.
Use the show ip igmp snooping groups command with parameters to see a
needed subset of all Multicast groups learned by IGMP snooping
To see the full Multicast address table (including static addresses), use the show
bridge multicast address-table command.
vlan-id address ip-multicast-address
] [
38
]
651