Show Lacp - Cisco 300 Series Cli Manual

40
670
Command Mode
Interface Configuration (Ethernet) mode
Example
The following example assigns a long administrative LACP timeout to gi6.
switchxxxxxx(config)# interface gi6
switchxxxxxx(config-if)# lacp timeout long
40.4

show lacp

Use the show lacp EXEC mode command to display LACP information for all
Ethernet ports or for a specific Ethernet port.
Syntax
interface-id [parameters | statistics | protocol-state
show lacp
Parameters
•
interface-id —Specify an interface ID. The interface ID must be an Ethernet
port
•
parameters—Displays parameters only.
•
statistics—Displays statistics only.
•
protocol-state—Displays protocol state only.
Command Mode
EXEC mode
Example
The following example displays LACP information for gi1.
switchxxxxxx# show lacp ethernet
gi
Port 1 LACP parameters:
Actor
Link Aggregation Control Protocol (LACP) Commands
gi
1
78-21075-01 Command Line Interface Reference Guide
]