Macro Description - Cisco 300 Series Cli Manual

Small business 300 series managed switches command line interface guide release 1.3

Hide thumbs Also See for 300 Series:

Table of Contents

Macro Commands

78-21075-01 Command Line Interface Reference Guide

appended to the macro history of the interface. The

displays the macro history of an interface.

A macro applied to an interface range behaves the same way as a macro applied

to a single interface. When a macro is applied to an interface range, it is applied

sequentially to each interface within the range. If a macro command fails on one

interface, it is nonetheless attempted to be applied and may fail or succeed on the

remaining interfaces.

Example 1 - The following is an example of a macro being applied to an interface

with the trace option.

switchxxxxxx(config) #

switchxxxxxx<config-if> #

Applying command...

switchxxxxxx<config-if> #

Example 2 - The following is an example of a macro being applied without the

trace option.

switchxxxxxx(config) # interface gi2

switchxxxxxx<config-if> #

Example 3 - The following is an example of an incorrect macro being applied.

switchxxxxxx(config-if)#macro trace dup

Applying command...'duplex full'

Applying command...'speed auto'

% bad parameter value

macro description

Use the macro description Interface Configuration mode command to append a

description, for example, a macro name, to the macro history of an interface. Use

the no form of this command to clear the macro history of an interface. When the

interface gi2

macro trace dup $DUPLEX full $SPEED 100

'duplex full'

macro apply dup $DUPLEX full $SPEED 100

show parser macro