Show Qos Statistics - Cisco 300 Series Cli Manual

49
836
Syntax
qos statistics queues
no qos statistics queues
Parameters
•
set—Specifies the counter set number.
•
interface—Specifies the Ethernet port.
•
queue—Specifies the output queue number.
•
dp—Specifies the drop precedence. The available values are: high, low.
Default Configuration
Set 1: All interfaces, all queues, high DP.
Set 2: All interfaces, all queues, low DP.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
If the queue parameter is all, traffic in cascading ports is also counted.
Example
The following example enables QoS statistics for output queues for counter set 1.
switchxxxxxx(config)#

49.42 show qos statistics

Use the show qos statistics EXEC mode command to display Quality of Service
statistical information.
Syntax
show qos statistics
set {queue | all} {dp | all} {interface | all}
set
qos statistics queues
78-21075-01 Command Line Interface Reference Guide
Quality of Service (QoS) Commands
1
all all all