Smartport Switchport Trunk Native Vlan - Cisco 300 Series Cli Manual

Smartport Commands
OL-32830-01 Command Line Interface Reference Guide

44.16 smartport switchport trunk native vlan

Use the smartport switchport trunk native vlan Interface Configuration (Ethernet,
port-channel) mode command to define the native VLAN when the interface is in
trunk mode. Use the no form of this command to restore the default configuration.
Syntax
smartport switchport trunk native vlan
Parameters
•
native-vlan-id
—Specifies the native VLAN ID.
Default Configuration
VLAN 1
Command Mode
Interface (Ethernet, Port Channel) Configuration mode
User Guidelines
This command is an extension of the
(Non-ISCLI)switchport trunk native vlan (Non-ISCLI)
switchport trunk native vlan (Non-ISCLI)
applied to the default VLAN when the interface belongs to the default VLAN as
egress tagged port.
Example
Define the native VLAN when port 1 is in trunk mode:
switchxxxxxx(config)#
switchxxxxxx(config-if)#
native
switchport trunk native vlan
CLI command, this command may also be
interface gi11
smartport switchport trunk native vlan 1
vlan-id
-
CLI command. Unlike the
44
854