Address Table Commands
78-21075-01 Command Line Interface Reference Guide
Default Configuration
Unregistered Multicast addresses are forwarded.
Command Mode
Interface Configuration (Ethernet, Port-Channel) mode
User Guidelines
Do not enable unregistered Multicast filtering on ports that are connected to
routers, because the 224.0.0.x address range should not be filtered. Note that
routers do not necessarily send IGMP reports for the 224.0.0.x range.
You can execute the command before the VLAN is created.
Example
The following example specifies that unregistered Multicast packets are filtered
on gi1:
switchxxxxxx(config)#
switchxxxxxx(config-if)#
29.15 bridge multicast forward-all
Use the bridge multicast forward-all Interface Configuration (VLAN) mode
command to enable forwarding all multicast packets for a range of ports or port
channels. Use the no form of this command to restore the default configuration.
Syntax
bridge multicast forward-all
port-channel-list}
no bridge multicast forward-all
Parameters
•
add—Forces forwarding of all Multicast packets.
•
remove—Does not force forwarding of all Multicast packets.
interface gi1
bridge multicast unregistered filtering
{add | remove} {ethernet interface-list | port-channel
29
421