Auto-Configuration; Boot Host Auto-Config - Cisco 300 Series Cli Manual

Auto-Configuration

78-21075-01 Command Line Interface Reference Guide
10.1

boot host auto-config

Use the boot host auto-config Global Configuration mode command to enable
DHCP auto configuration via either the TFTP or SCP protocols. Use the no form of
this command to disable DHCP auto configuration.
Syntax
boot host auto-config [tftp | scp | auto [
no boot host auto-config
Parameters
•
ftp—Only the TFTP protocol is used by auto-configuration.
•
scp—Only the SCP protocol is used by auto-configuration.
•
auto—(Default) Auto-configuration uses the TFTP or SCP protocol depending
on the configuration file's extension. If this option is selected, the extension
parameter may be specified or, if not, the default extension is used.
•
extension—The SCP file extension. When no value is specified, 'scp' is used.
(Range: 0–128)
Default Configuration
The auto option is the default.
Command Mode
Global Configuration mode
Default Configuration
Enabled by default.
Examples
Example 1 - The following example specifies the auto mode and specifies "scon"
as the SCP extension:
boot host auto-config auto scon
extension
]]
10
185