37
Link Layer Discovery Protocol (LLDP) Commands
Command Mode
Interface Configuration (Ethernet) mode
Example
The following example enables sending LLDP MED topology change notifications
on gi2.
switchxxxxxx(config)#
interface gi2
switchxxxxxx(config-if)#
lldp med notifications topology-change enable
37.16 lldp med fast-start repeat-count
When a port comes up, LLDP can send packets more quickly than usual using its
fast-start mechanism.
Use the lldp med fast-start repeat-count Global Configuration mode command to
configure the number of packets that is sent during the activation of the fast start
mechanism. Use the no form of this command return to default.
Syntax
number
lldp med fast-start repeat-count
no lldp med fast-start repeat-count
Parameters
number
repeat-count
—Specifies the number of times the fast start LLDPDU is
being sent during the activation of the fast start mechanism. The range is 1-10.
Default Configuration
3
Command Mode
Global Configuration mode
Example
switchxxxxxx
(config)# lldp med fast-start repeat-count 4
614
78-21075-01 Command Line Interface Reference Guide