Management Acl Commands; Management Access-List - Cisco 300 Series Cli Manual

Management ACL Commands

78-21075-01 Command Line Interface Reference Guide
11.1

management access-list

The management access-list Global Configuration mode command configures a
management access list (ACL) and enters the Management Access-List
Configuration command mode. Use the no form of this command to delete an ACL
Syntax
management access-list
no management access-list
Parameters
name—Specifies the ACL name. (Length: 1–32 characters)
Default Configuration
N/A
Command Mode
Global Configuration mode
User Guidelines
Use this command to configure a management access list. This command enters
the Management Access-List Configuration mode, where the denied or permitted
access conditions are defined with the deny and permit commands.
If no match criteria are defined, the default value is deny.
When re-entering the access-list context, the new rules are entered at the end of
the access list.
Use the management access-class
The active management list cannot be updated or removed.
For IPv6 management traffic that is tunneled in IPv4 packets, the management ACL
is applied first on the external IPv4 header (rules with the service field are
ignored), and then again on the inner IPv6 header.
name
name
command to select the active access list.
11
190