Dhcp Server Commands; Ip Dhcp Server; Ip Dhcp Pool Host - Cisco 300 Series Cli Manual

DHCP Server Commands

78-21075-01 Command Line Interface Reference Guide
53.1

ip dhcp server

Use the ip dhcp server Global Configuration mode command to enable the DHCP
server features on the device.
Use the no form of this command to disable the DHCP server.
Syntax
ip dhcp server
no ip dhcp server
Default Configuration
The DHCP server is disabled.
Command Mode
Global Configuration mode
Example
The following example enables the DHCP server on the device:
ip dhcp server
Console(config)#
53.2

ip dhcp pool host

Use the ip dhcp pool host Global Configuration mode command to configure a
DHCP static address on a DHCP Server and enter the DHCP Pool Host
Configuration mode.
Use the no form of this command to remove the address pool.
Syntax
name
ip dhcp pool host
no ip dhcp pool host
Parameters
name—Specifies the DHCP address pool name. It can be either a symbolic string
(such as Engineering) or an integer (such as 8). (Length: 1–32 characters)
name
53
874