Flowcontrol - Cisco 300 Series Cli Manual

Ethernet Configuration Commands
78-21075-01 Command Line Interface Reference Guide
Command Mode
Interface Configuration (Ethernet, Port-channel) mode
Example
The following example enables auto-negotiation on gi5.
switchxxxxxx (config)#
(config-if)#
switchxxxxxx
23.9

flowcontrol

Use the flowcontrol Interface Configuration (Ethernet, Port-channel) mode
command to configure the Flow Control on a given interface. Use the no form of
this command to disable Flow Control.
Syntax
flowcontrol {auto | on | off}
no flowcontrol
Parameters
•
auto—Specifies auto-negotiation of Flow Control.
•
on—Enables Flow Control.
•
off—Disables Flow Control.
Default Configuration
Flow control is disabled.
Command Mode
Interface Configuration (Ethernet, Port-channel) mode
User Guidelines
Use the negotiation command to enable flow control auto.
interface gi5
negotiation
23
353