Ip Igmp Snooping Vlan Mrouter - Cisco 300 Series Cli Manual

38
636
Parameters
vlan-id
vlan —Specifies the VLAN.
Default Configuration
Disabled
Command Mode
Global Configuration mode
User Guidelines
IGMP snooping can be enabled only on static VLANs.
IGMPv1, IGMPv2 and IGMPv3 are supported.
To activate IGMP snooping, the
The user guidelines of the
command describes the configuration that is written into the FDB as a function of
the FDB mode and the IGMP version that is used in the network.
Example
switchxxxxxx(config)# ip igmp snooping vlan 2
38.3

ip igmp snooping vlan mrouter

Use the ip igmp snooping vlan mrouter Global Configuration mode command to
enable automatic learning of Multicast router ports on a VLAN. Use the no form of
this command to remove the configuration.
Syntax
ip igmp snooping vlan
no ip igmp snooping vlan
Parameters
vlan-id
vlan —Specifies the VLAN.
Default Configuration
Learning pim-dvmrp is enabled.
bridge multicast filtering
bridge multicast mode
vlan-id
mrouter learn pim-dvmrp
vlan-id
mrouter learn pim-dvmrp
78-21075-01 Command Line Interface Reference Guide
IGMP Snooping Commands
should be enabled.
Interface VLAN Configuration