Cisco 300 Series Cli Manual page 739

Small business 300 series managed switches command line interface guide release 1.3

Hide thumbs Also See for 300 Series:

Table of Contents

IPv6 Router Commands

78-21075-01 Command Line Interface Reference Guide

FF02::1:FF11:6770

MTU is 1500 bytes

ICMP error messages limited interval is 100ms; Bucket size is 10 tokens

ND DAD is enabled, number of DAD attempts: 1

ND reachable time is 30000 milliseconds

Stateless autoconfiguration is enabled.

MLD Version is 2

Field Descriptions:

vlan 1 is up/up—Indicates the interface status: administrative/operational.

IPv6 is enabled, stalled, disabled (stalled and disabled are not shown in

sample output)—Indicates that IPv6 is enabled, stalled, or disabled on the

interface. If IPv6 is enabled, the interface is marked Enabled. If duplicate

address detection processing identified the link-local address of the

interface as being a duplicate address, the processing of IPv6 packets is

disabled on the interface and the interface is marked Stalled. If IPv6 is not

enabled, the interface is marked Disabled.

link-local address—Displays the link-local address assigned to the

Global unicast address(es):—Displays the global Unicast addresses

assigned to the interface. The type is manual or autoconfig.

Joined group address(es):—Indicates the Multicast groups to which this

interface belongs.

—Maximum transmission unit of the interface.

ICMP error messages—Specifies the minimum interval (in milliseconds)

between error messages sent on this interface.

ND DAD—The state of duplicate address detection on the interface

(enabled or disabled).

number of DAD attempts:—Number of consecutive neighbor solicitation

messages that are sent on the interface while duplicate address detection

is performed.

ND reachable time—Displays the neighbor discovery reachable time (in

milliseconds) assigned to this interface.