Spanning-Tree Disable; Spanning-Tree Cost - Cisco 300 Series Cli Manual

31
456
Example
The following example configures the spanning-tree priority to 12288.
switchxxxxxx(config)#
31.7

spanning-tree disable

Use the spanning-tree disable Interface Configuration (Ethernet, port-channel)
mode command to disable the spanning tree on a specific port. Use the no form of
this command to enable the spanning tree on a port.
Syntax
spanning-tree disable
no spanning-tree disable
Parameters
N/A
Default Configuration
Spanning tree is enabled on all ports.
Command Mode
Interface Configuration (Ethernet, port-channel) mode
Example
The following example disables the spanning tree on gi5
switchxxxxxx(config)#
switchxxxxxx(config-if)#
31.8

spanning-tree cost

Use the spanning-tree cost Interface Configuration (Ethernet, port-channel) mode
command to configure the spanning-tree path cost for a port. Use the no form of
this command to restore the default configuration.
spanning-tree priority
interface gi5
spanning-tree disable
78-21075-01 Command Line Interface Reference Guide
Spanning-Tree Commands
12288