Ethernet Configuration Commands
78-21075-01 Command Line Interface Reference Guide
Parameters
•
time-range-name—Specifies a time range the port operates (in up state).
When the Time Range is not in effect, the port is shutdown. (Range: 1–32
characters)
Default Configuration
There is no time range configured on the port authorized state.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
It is recommended to disable spanning tree or to enable spanning-tree PortFast
mode on 802.1x edge ports (ports in auto state that are connected to end stations),
in order to proceed to the forwarding state immediately after successful
authentication.
Example
The operation time command influences the port if the port status is up. This
command defines the time frame during which the port stays up and at which time
the port will be shutdown. While the port is in shutdown because of other reasons,
this command has no effect.
The following example activates an operation time range (named "morning") on
gigabitethernet port 1/1/15.
switchxxxxxx(config)#
switchxxxxxx(config-if)#
23.5
description
Use the description Interface Configuration (Ethernet, Port-channel) mode
command to add a description to an interface. Use the no form of this command to
remove the description.
Syntax
string
description
no description
interface gi15
operation time morning
23
349