Storm-Control Include-Multicast - Cisco 300 Series Cli Manual

23
368
Default Configuration
•
level—10%
•
kbps—10% of port speed in Kbps
Command Mode
Interface Configuration mode (Ethernet)
User Guidelines
Use the storm-control broadcast enable
enable storm control.
The calculated rate includes the 20 bytes of Ethernet framing overhead
(preamble+SFD+IPG).
Example
switchxxxxxx(config)# interface gi1
switchxxxxxx(config-if)# storm-control broadcast level 50 kbps 12345

23.24 storm-control include-multicast

Use the storm-control include-multicast Interface Configuration mode command
to count Multicast packets in a Broadcast storm control. Use the no form of this
command to disable counting of Multicast packets in the Broadcast storm control.
Syntax
storm-control include-multicast
no storm-control include-multicast
Parameters
unknown-unicast—Specifies also the count of unknown unicast packets.
Default Configuration
Disabled
Command Mode
Interface Configuration mode (Ethernet)
Ethernet Configuration Commands
Interface Configuration command to
[unknown-unicast]
78-21075-01 Command Line Interface Reference Guide