Cisco 300 Series Cli Manual page 414

29
414
Parameters
•
mac-group—Specifies that Multicast bridging is based on the packet's
VLAN and MAC destination address.
•
ip-group—Specifies that Multicast bridging is based on the packet's VLAN
and IPv6 destination address for IPv6 packets.
•
ip-src-group—Specifies that Multicast bridging is based on the packet's
VLAN, IPv6 destination address and IPv6 source address for IPv6 packets.
Default Configuration
The default mode is mac-group.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
Use the mac-group mode when using a network management system that uses a
MIB based on the Multicast MAC address.
For each Forwarding Data Base (FDB) mode, use different CLI commands to
configure static entries for IPv6 Multicast addresses in the FDB, as described in
the following table::
FDB Mode
mac-group bridge multicast address
ipv6-group bridge multicast ipv6
ip-address
ipv6-src-group bridge multicast ipv6 source
group
The following table describes the actual data that is written to the Forwarding
Data Base (FDB) as a function of the MLD version that is used in the network:(*)
FDB mode MLD version 1
mac-group MAC group
address
ipv6-group IPv6 group
address
ipv6-src-group (*)
CLI Commands
bridge multicast forbidden
address
bridge multicast ipv6
forbidden ip-address
bridge multicast ipv6
forbidden source group
MLD version 2
MAC group address
IPv6 group address
IPv6 source and group
addresses
78-21075-01 Command Line Interface Reference Guide
Address Table Commands