Port-Channel Load-Balance; Show Interfaces Port-Channel - Cisco 300 Series Cli Manual

28
400
28.2

port-channel load-balance

Use the port-channel load-balance Global Configuration mode command to
configure the load balancing policy of the port channeling. Use the no form of this
command to reset to default.
Syntax
port-channel load-balance
no port-channel load-balance
Parameters
•
src-dst-mac—Port channel load balancing is based on the source and
destination MAC address.
•
src-dst-mac-ip—Port channel load balancing is based on the source and
destination of MAC and IP addresses.
Default Configuration
src-dst-mac is the default option.
Command Mode
Global Configuration mode
Example
switchxxxxxx(config)# port-channel load-balance src-dst-mac
switchxxxxxx(config)# port-channel load-balance src-dst-mac-ip
28.3

show interfaces port-channel

Use the show interfaces port-channel EXEC mode command to display
port-channel information for all port channels or for a specific port channel.
Syntax
show interfaces port-channel
{src-dst-mac| src-dst-mac-ip}
[interface-id]
78-21075-01 Command Line Interface Reference Guide
Port Channel Commands