35
Smartport Commands
Command Mode
Interface Configuration (Ethernet, port-channel) mode
Examples
Example 1 - Set the maximum number of kilobits per second of Broadcast traffic
on port 1 to 10000.
switchxxxxxx(config)interface gi1
switchxxxxxx(config-if)#smartport storm-control broadcast level kpbs 10000
Example 2 - Set the maximum percentage of kilobits per second of Broadcast
traffic on port 1 to 30%.
switchxxxxxx(config)interface gi1
switchxxxxxx(config-if)#smartport storm-control broadcast level 30
35.19 smartport storm-control include-multicast
Use the smartport storm-control include-multicast Interface Configuration mode
command to count Multicast packets in a Broadcast storm control. Use the no form
of this command to disable counting of Multicast packets in the Broadcast storm
control.
Syntax
[unknown-unicast]
smartport storm-control include-multicast
no smartport storm-control include-multicast
Parameters
unknown-unicast—Specifies also the count of unknown Unicast packets.
Default Configuration
Disabled
Command Mode
Interface Configuration mode (Ethernet)
574
78-21075-01 Command Line Interface Reference Guide