Ip Http Timeout-Policy - Cisco 300 Series Cli Manual

13
Web Server Commands
no ip http port
Parameters
port-number
port —For use by the HTTP server. (Range: 0–65534)
Default Configuration
The default port number is 80.
Command Mode
Global Configuration mode
Example
The following example configures the http port number as 100.
switchxxxxxx(config)# ip http port 100
13.3

ip http timeout-policy

Use the ip http timeout-policy Global Configuration mode command to set the
interval for the system to wait for user input in http/https sessions before
automatic logoff. Use the no form of this command to return to the default value.
Syntax
idle-seconds
ip http timeout-policy [http-only | https-only]
no ip http timeout-policy
Parameters
idle-seconds—Specifies the maximum number of seconds that a connection is
kept open if no data is received or response data cannot be sent out. (Range:
0–86400)
http-only —The timeout is specified only for http
https-only— The timeout is specified only for https
Default Configuration
600 seconds
224 78-21075-01 Command Line Interface Reference Guide