Cisco 300 Series Cli Manual page 812

49
812
Syntax
queue-id cos0
wrr-queue cos-map
no wrr-queue cos-map [
Parameters
•
queue-id—Specifies the queue number to which the CoS values are
mapped.
•
cos0... cos7—Specifies up to 8 CoS values to map to the specified queue
number. (Range: 0–7)
Default Configuration
The default CoS value mapping to 4 queues is as follows:
•
CoS value 0 is mapped to queue 1.
•
CoS value 1 is mapped to queue 1.
•
CoS value 2 is mapped to queue 2.
•
CoS value 3 is mapped to queue 3.
•
CoS value 4 is mapped to queue 3.
•
CoS value 5 is mapped to queue 4.
•
CoS value 6 is mapped to queue 4.
•
CoS value 7 is mapped to queue 4.
Command Mode
Global Configuration mode
User Guidelines
Use this command to distribute traffic to different queues.
Example
The following example maps CoS value 4 and 6 to queue 2.
switchxxxxxx(config)#
cos7
...
queue-id
]
wrr-queue cos-map 2 4 6
78-21075-01 Command Line Interface Reference Guide
Quality of Service (QoS) Commands